glider rocker bearings
glider rocker bearings
Author :Admin | Publish Date:2013-05-14 11:29:08
Don't need the whole Bearing Kit just one bearing with fasteners? Then this
is what you need. About the bearings: These bearings are made by the same
American manufacturer that has been making bearings for glider rockers since the rockers were invented. They are a low speed
bearing made of steel construction throughout. They have a light zinc finish and
are lightly greased internally when assembled. The metal shield prevents dusts
and contaminants from easily entering the bearing. The bore is smooth and fits a
standard 3/8" bolt perfectly. This allows you to use any length bolt you need to
build or repair your rocker. We have personally repaired several rockers with
this bearing with great success and happy customers.
Please note we do not have brand specific data... we only know that this
bearing fits many chairs. Please scroll down to the bottom of this page for
specific measurements.Please review the measurements below to make sure this kit
is what you need because we will not accept returns... due to the large amount
of customers who are not measuring to make sure these ina bearings fit their chair.
Please note we do not have brand specific data (even if you call us - we
still don't know)... we only know that this bearing fits many chairs. Please
scroll down to the bottom of this page for specific measurements. This hardware
kit is what you need to build one rocker. You will need to drill a 1-1/8" hole
for the bearings to push into. We highly recommend using nothing but hardwoods.
The bolts, nuts and washers are 3/8". The screws are #6 square recess drive.
This produces the same simple arrangement as used by the chair
manufacturers.
About the bearings: These fag bearings are
made by the same American manufacturer that has been making bearings for glider
rockers since the rockers were invented. They are a low speed bearing made of
steel construction throughout. They have a light zinc finish and are lightly
greased internally when assembled. The metal shield prevents dusts and
contaminants from easily entering the bearing. The bore is smooth and fits a
standard 3/8" bolt perfectly. This allows you to use any length bolt you need to
build or repair your rocker. We have personally repaired several rockers with
this bearing with great success and happy customers.
Please review the measurements below to make sure this kit is what you need
because we will not accept returns... due to the large amount of customers who
are not measuring to make sure these glider
rocker bearings fit their chair. Also please note we do not have brand
specific data (even if you call us - we still don't know)... we only know that
this bearing fits many chairs. Please scroll down to the bottom of this page for
specific measurements.
BRING SKF RLS 12 (1 1/2 X 3 1/4 X 3/4)
BRING SKF RLS 14 (1 3/4 X 3 3/4 X 13/16)
BRING SKF RLS 15 (1 7/8 X 4 X 13/16)
Prev:glider rocker bearings Next:glider rocker bearings